3" Stainless Steel Restrictor Plate Gasket – 1/8" Pilot Hole
The 3" restrictor plate gasket is designed for dairy pipeline and wash systems that require a controlled restriction in a 3" connection. The assembly uses a 316 stainless-steel restrictor plate with a 1/8" pilot opening rather than leaving the full pipeline diameter open.
The small fixed opening creates a controlled resistance to flow and can help establish the pressure differential, water movement, or air admission required by a properly designed dairy pipeline or CIP wash system.
Key Features
- For 3" dairy pipeline connections
- 1/8" fixed pilot-hole restriction
- 316 stainless-steel restrictor plate
- Fixed flow-control design with no moving parts
- Creates a repeatable restriction in compatible systems
- Can help regulate water or air movement during CIP operation
- Replaceable pipeline component
- SKU: 46453
Why Use a Restrictor in a Large Pipeline?
A 3" pipeline has considerably more open cross-sectional area than the smaller lines commonly used on many dairy systems. Where a wash-system design calls for controlled flow, a restrictor plate provides a simple method of reducing that passage at a specific location.
The plate does not reduce the size of the entire pipeline. Instead, it creates a localized fixed restriction where the plate is installed.
Use in Clean-In-Place Washing
CIP cleaning depends on adequate solution movement and mechanical action inside the pipeline. On systems using vacuum and air injection, the amount and timing of water and air entering the line influence the formation and movement of wash slugs.
A properly located restrictor can help control those conditions so the system operates as designed. Restrictor placement and orifice size should therefore match the existing wash-system configuration.
Keep the Pilot Hole Clear
The 1/8" opening is the calibrated flow path through the plate. Inspect it periodically for deposits or debris that could reduce the effective opening and alter system performance.
When replacing an existing plate, use the same pipeline and pilot-hole size unless a qualified system evaluation calls for a change.
Select the Correct Pipeline Size
- 1-1/2" Restrictor Plate Gasket – SKU 46450
- 2" Restrictor Plate Gasket – SKU 46451
- 2-1/2" Restrictor Plate Gasket – SKU 46452
- 3" Restrictor Plate Gasket – SKU 46453
- 4" Restrictor Plate Gasket – SKU 46454
View all Pipeline Gaskets & Clamps »
Need Help Selecting the Correct Restrictor?
Contact Parts Department at 800-245-8222 for help evaluating your pipeline size, CIP washer setup, and restrictor requirements.