REBUILT SURGE 75 HEAD W/OILER
Rebuilt Surge 75 Vacuum Pump Head with Oiler
Professionally rebuilt Surge 75 dairy vacuum pump head with oiler. This rotary-vane vacuum pump is designed for dairy barns, pipeline milking systems, and milking parlors where dependable vacuum is essential for consistent milking performance.
This pump-head-only option is ideal for customers who already have a usable motor, stand, pulley system, or other vacuum-system components and need to replace or rebuild the primary vacuum pump without purchasing a complete assembled package.
Surge 75 Pump Specifications
- Pump: Surge 75
- Pump Type: Oil-lubricated rotary-vane vacuum pump
- Pump Shaft Diameter: 1-1/8"
- Typical 5 HP Pump Speed: Approximately 940 RPM
- Typical 5 HP Vacuum Capacity: Approximately 45 CFM
- Configuration: Rebuilt pump head with oiler
The RPM and CFM figures above are based on the common 5 HP Surge 75 configuration. Actual pump speed depends on the motor and pulley combination used in your installation.
Professionally Rebuilt
Parts Department rebuilt vacuum pumps are thoroughly serviced before being offered for sale. Critical wear areas are inspected and corrected to help restore dependable operation in a dairy vacuum system.
- Rotor clearance reset as required
- Pump housing honed
- End plates resurfaced
- New vanes installed
- New bearings installed
- New shaft seals installed
- Oil lines, drippers, and filters replaced where applicable
- Pump tested after rebuilding to verify proper operation
Rebuilt pump assemblies include a 3-month warranty.
What Is Included
This listing is for the rebuilt Surge 75 vacuum pump head with oiler. It is intended for customers who are repairing an existing vacuum system or building a pump package using compatible components already on hand.
This is not the complete motor-and-stand pump package. If you need a Surge 75 already assembled with a motor, stand, and oil reclaimer, see the complete package below.
View the Rebuilt Surge 75 with 5 HP Motor, Stand & Reclaimer »
Designed for Dairy Vacuum Systems
The Surge 75 is a proven dairy vacuum pump designed for the continuous vacuum requirements of milking equipment. In the common 5 HP configuration, the pump provides approximately 45 CFM at approximately 940 RPM.
Proper vacuum-pump sizing depends on the complete milking system, including the number of milking units, pipeline configuration, reserve requirements, regulators, receivers, and other equipment connected to the vacuum system.
If you are replacing a different pump or changing pulley or motor sizes, contact Parts Department so we can help confirm the appropriate setup.
Rebuilt Equipment Note
This is professionally rebuilt Surge equipment. Because rebuilt vacuum pumps use serviceable original components, cosmetic appearance may vary from one pump to another.
Paint finish, oiler appearance, fittings, and other non-critical visual details may vary. The important specifications are the Surge 75 pump model, shaft size, rebuilt condition, and included oiler described in this listing.
Related Surge 75 Service Parts
Parts Department carries replacement components for maintaining and servicing Surge 75 vacuum pumps.
- Vanes for Surge 60/75/100 Vacuum Pumps – 4/Set – SKU 948197
- Double-Row Bearing for Surge 40/60/75/100 – SKU 90008
- Needle Bearing Race for Surge 40/60/75/100 – SKU 05450
- 2" Vacuum Pump Oil Reclaimer – Up to 10 HP – SKU 63247
View all Westfalia & Surge Vacuum Pump Parts »
Need Help With Your Surge Vacuum Pump?
Contact Parts Department at 800-245-8222 for assistance with Surge 75 vacuum pumps, replacement parts, pulley sizing, or dairy vacuum-system setup. If you are replacing an existing pump, having the current pump model, motor horsepower, pulley sizes, and a photo of the installation available can help us identify the correct configuration.